Joyor Electric Scooter User Manual

Joyor Electric Scooter The Main Parts

  1. LCD display

  2. Lever lock for handlebar height adjustment

  3. Handlebar folding sleeve

  4. Brake wire

  5. Front suspension

  6. Front light

  7. Front mudguard

  8. Folding system

  9. Rear light

  10. Parking stand

  11. Brake handle

  12. Front air tire

  13. Rear solid tire

  14. Rear mudguard

  15. Rear drum brake

 

Joyor Electric Scooter A/F Series

Joyor Electric Scooter X Series

Joyor Electric Scooter Y Series

  1. LCD display

  2. Lever lock for handlebar height adjustment 

  3. Handlebar folding sleeve

  4. Brake wire

  5. Front suspension

  6. Front light

  7. Front mudguard

  8. Folding system

  9. Rear light

  10. Parking stand

  11. Brake handle

  12. Front air tire 

  13. Rear air tire

  14. Rear mudguard

  15. Rear disk brake

  1. LCD display

  2. Lever lock for handlebar height adjustment

  3. Handlebar folding sleeve

  4. Brake wire

  5. Double front suspension

  6. Front light

  7. Front mudguard

  8. Folding system

  9. Rear light

  10. Parking stand

  11. Brake handle

  12. Seat (optional)

  13. Lever lock for the seat tube height adjustment

  14. Seat folding system

  15. Front air tire 

  16. Rear air tire

  17. Double rear suspension

  18. Rear mudguard

  19. Front turning signal

  20. Rear turning signal

  21. Front and rear disk brake

Joyor Electric Scooter Safety Instructions

 

  • Joyor electric scooter is a personal transport vehicle and it is designed for one person use only. Please do not carry a passenger on this electric scooter. 

  • Joyor electric scooter is designed for adult use only. Persons under the age of 16 should not use this vehicle.

  • Please wear the safety helmet when riding the electric scooter.

  • Do not ride the electric scooter on the unsafe surface or offroad.

  • Please practice riding the electric scooter on an open traffic-free space on gear level 1 before riding on the bicycle lane. 

  • Please during the riding operations always keep both hands on the handlebar and both feet on the standing board of the electric scooter. Please do not jump on the standing board of the electric scooter.

  • Do not turn off the motor power while riding the electric scooter.

  • Do not try to ride over a gap of more than 3 cm. This may cause injury to the rider or damage the electric scooter.

  • When riding on the rough or bumpy road, please slow down the electric scooter or stop riding the vehicle

  • A user must adjust the height of the handlebar tube of the electric scooter according to their height to ensure a safe, stable and comfortable ride.

  • Do not ride Joyor electric scooter on slippery surfaces such as oil or ice.

  • Do not use Joyor electric scooter in the weather conditions with the temperature below -5.

  • Do not leave Joyor electric scooter immersed in a water depth of more than 3 cm to avoid damage to the electrical parts of the vehicle.

  • Avoid riding the Joyor electric scooter in adverse weather conditions like rain, snow or wind storm to prevent an accident. If riding Joyor electric scooter in these conditions, never exceed the speed of 10 km/h.

  • If the electric scooter is not used for a period of longer than 30 days, regularly charge it at least every 30 days. 

  • When unfolding Joyor electric scooter, please press the folding system handle till it clicks and make sure that it is in place.

 

How to Fold/Unfold Joyor Electric Scooter

 
 

Joyor Electric Scooter Display & Parameter Settings

  1. On/Off Switch

  2. Gear switch

  3. Acceleration handle

  4. Gear indicator

  5. Speed indicator

  6. Multi-indication area/mileage indicator

  7. Battery charge level indicator

  8. USB charging port

 

The Buttons

 

  • Long press the ON/OFF button to turn on the display, short press the ON/OFF to switch between ODO, TRIP, V, A, E, TM in the multi-indicator

  • Long press the ON/OFF to turn off the display

  • Long press the M and ON/OFF at the same time to enter into the parameter settings mode. Short press the ON/OFF button to switch between parameters. Short press M to change the settings. Long press the M and ON/OFF at the same time to save and exit

  • Long press M to turn on the lights

 

Display Functions

 

Speed indication, power indication, error code indication, lights control, cruise control, gear level switch and gear indicator, total mileage, single mileage, real-time voltage, running time, acceleration control

 

Multi-indicator Area         

 

Total mileage ODO, single mileage TRIP, real-time voltage V, running time TIME, error code E

 

Error Code Indicator

 

When the symbol ! is flashing, short press ON / OFF switch button to enter into the error analysis mode. Each number of the error code corresponds to a specific problem as follows:

 

ERRO 1: Motor fault

ERRO 2: Throttle fault

ERRO 3: Controller fault

ERRO 4: Brake lever power off

ERRO 5: Undervoltage protection

ERRO 6: Communication fault, the display unable to get the output from the controller

ERRO 7: Communication fault, the controller unable to get the output from the display

 

Speed Indicator

 

Unit: MPH, KM/H

 

Speed signal comes from the motor via controller to the display.

The indicated speed depends on the motor signal and the wheel diameter.

 

Gear Switch

 

Short press the MODE button to switch the gear: 1 - slow, 2 - medium, 3 - fast. The higher the gear, the faster the speed. Gear 0 means the motor is not powered. 

 

Lights Control

 

Long press the MODE key to switch on/off the front and rear lights. Rear lights are also lit automatically when braking.

 

Cruise Control Function

 

When riding the scooter, keep the acceleration handle pressed with the same pressure for 5 seconds to activate the cruise control mode. Use the brake handle to deactivate the cruise control mode.

 

Start mode selection

 

For safety purposes all Joyor models except Mbike model are set by default to non-zero start mode which means the motor will not get started until you start kick the scooter first so that the speed is above zero:

 

NON - Non-zero start mode

ZERO - zero start mode

 

USB Charging Indicator

 

The display is equipped with a USB port for you to be able to charge your electronic devices. When the device is connected, the USB indicator is lit. In cae of problem the indicator starts to flash, and a safety mode will be automatically activated.

 

Parameter Settings

 

Long press the M and ON/OFF at the same time to enter into the parameter settings mode. Short press the ON/OFF button to switch between parameters. Short press M to change the settings. Long press the M and ON/OFF at the same time to save and exit.

 

P01: rear light brightness: 1 - the darkest, 3 - the lightest;

P02: mileage unit, 0: km; 1: mile;

P04: sleep mode time: 0 - no sleep mode; 1-60 - sleep mode, minutes;

P06: wheel diameter: unit - inch; precision: 0.1;

P07: number of measuring magnets: range 1-100;

P09: zero start, non-zero start setting: 0 - zero start; 1 - nonzero start;

P12: starting torque: range 0-5, 0 - the weakest, 5 - strongest;

P15: motor drive signal percentage settings: (connected to PO8 speed limit function) full speed is set to 100

P16: cruise control function: 1 - activated, 0 - deactivated

P17: light settings: the lights are not lit automatically when the vehicle is on, 0 - the lights are lit automatically when the vehicle is on

 

 

 

 

 

 

How to Ride Joyor Electric Scooter

Before Riding

 

  • Choose a suitable venue for riding the electric scooter.

  • Unfold the electric scooter according to the instructions.

  • Adjust the height of the handlebar tube of the electric scooter according to your height.

 

Riding

 

  • Press the power button to turn on the power. The speed is set by default to gear level 1.

  • For safety purposes, Joyor electric scooter has a safe start design which means the motor can start only when the speed of the electric scooter is above 0. It prevents motor start when the acceleration handle is pressed by mistake. To start the riding operations, put one foot on the standing board of the electric scooter and the other foot on the ground and kick scoot it like a classic kick scooter. When the electric scooter is in motion and its speed is above 0, smoothly use the acceleration handle to start the motor. Once the motor starts, put the other foot on the standing board of the electric scooter and continue riding. 

  • When riding the electric scooter, adjust the gear level from 1 to 3, use lights and horn according to the road conditions and according to the situation. 

  • Be aware of the cruise control function. Cruise control function is activated when the acceleration handle is pressed with the same pressure for 3 seconds. 

  • Be aware of the possibility of unpredictable sudden obstacles on your way and control the speed level.

 

Braking

 

  • Use the rear brakes handle for braking under normal circumstances. Use front brake handle (for models series Y and M) for braking in emergency situations.

  • The greater pressure you put, the greater braking force will be applied. Be aware that hard braking may result in an accident due to slipping of the wheels, lost of balance and fall of the electric scooter. Hard braking might also cause damage to the tire.

 

 

 

 

 

Joyor Electric Scooter Maintenance 

Tires

 

  • Joyor electric scooter uses rubber elastic tires. When the tires are worn out or have a puncture, they need to be replaced timely.

  • Contact the official distributor to replace the original tires.

  • Inspect your electric scooter and its tires every month, check if the screws are tightened enough. If they are loose, tighten them.

 

Battery

 

  • Joyor electric scooter is equipped with a  ternary polymer lithium battery.  The average lifespan of the battery is 1000 cycles. Under normal use and maintenance, the battery lifespan can generally reach more than 1000 cycles.

  • Before using the electric scooter for the first time, please charge the battery to the full charge.

  • Avoid totally depleting your electric scooter’s battery before charging. Always make sure it is minimum 10 % charged. For satisfactory electric scooter performance, the battery has to be charged minimum 50 %

  • Do not leave your electric scooter with a significantly discharged battery for a few hours. Charge it promptly.

  • When storing the electric scooter for a long period, make sure the battery is at least 40-50 % charged. It is advisable to charge your scooter minimum once per 30 days.

  • Always use only the original Joyor charger that corresponds to the model of the electric scooter.

  • Do not leave your electric scooter in the cold temperature below 0 or under the direct sun. Keep the battery dry. Negative environmental conditions can damage the battery of the electric scooter.

  • Polymer lithium batteries have to be treated with extreme caution. Unappropriated charging, damage or overheating can result in a fire. Do not leave your electric scooter to charge without supervision. Do not leave the electric scooter to charge overnight. Always supervise the electric scooter while it is charging and avoid battery over-charge. Do not use, charge or leave a damaged battery unattended and follow the disposal protocols immediately.

 

Charger

 

The dedicated charger provided by Joyor Electric Scooter has a charging protection timing function.

 

Charging instructions

  • Open the charging port cover on the electric scooter and insert the charger output connector into the charging port.

  • Insert the charger input power plug into the power socket (AC110V-220V)

  • Charger light is red to indicate that charging is in progress; when the charger light turns green, it indicates that the battery is fully charged.

  • When charging the battery, place it in a dry, ventilated environment.

 

Brake

 

Joyor electric scooter is equipped with a rear brake (or a rear and a front brake for series Y and M), if the break pad is wearing out, please contact the distributor to fasten it or replace it. 

 

Solutions for general problems

 

In case Joyor electric scooter does not work properly, please check if you have completed the actions below:

 

  1. The power is on

  2. The battery level on the screen

  3. All the sockets and connectors are connected correctly.

 

 

If you have completed all the above actions and the electric scooter is still not working properly, please contact the distributor.

 

 
 
  • Facebook - Black Circle
  • Pinterest - Black Circle
  • Instagram - Black Circle
electric scooter joyor trottinette electrique

© 2017 Joyor Scooter, Spain

Contact Us

Email: info@joyorscooter.com

Phone: 931 419 091

Address: Carrer d'Enric Prat de la Riba, 100, 08301 Mataró, Barcelona, Spain

  • Facebook - Black Circle
  • Pinterest - Black Circle
  • Instagram - Black Circle